News:Operating methods for microswitches

Firstly, in the case of manually welding the microswitch, try to choose a temperature less than 320 ℃ and ensure that it is equipped within three seconds. At the same time, it must be noted that during work, pressure should not be applied to the wiring terminals, otherwise the mechanical equipment may not operate properly. If the switch uses a relatively small current or working voltage, it is best to use a low output power circuit, that is, an Au insulated contact point. At the same time, when using switches, special attention should be paid to moisture prevention, and the temperature should also be within the required range. Only by meeting all the above standards can these switches activate their highest foundation and ensure the daily operation of the facility. Only in this way can the service life of the switch be increased.
1) Application and operation methods of microswitches.
Apply microswitches.
Please do not press for a long time. Otherwise, it will accelerate the changes in the parts and change their characteristics.
Microswitch operation method.
The operation method of the microswitch endangers the characteristics of the switch.
Please use smooth switch operators (camshafts, stops, etc.). The switch drive rod can be quickly recovered, and if damaged, it may damage the drive rod and reduce its service life.
2) Application and operation methods of microswitches.
During operation, please do not add a partial load to the drive rod. Otherwise, partial friction may damage the drive rod and reduce its service life.
Please operate according to the posture and position of the drive lever. In the scale button type, press the button vertically.